Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NetFlow on a Frame Relay - sub interface

I have a frame relay sub interface which is doing frame-relay payload-compression packet-by-packet. Is it possible to configure netflow on this interface. Eventhough I configure on the main netflow entries pertaining to these interfaces are not available in the netflow cache. Please help

3 REPLIES
Bronze

Re: NetFlow on a Frame Relay - sub interface

To configure NetFlow, first configure the router for IP routing Use the following commands beginning in global configuration mode:

interface type slot/port-adapter/port (Specify the interface, and enter interface configuration mode.)

ip route-cache flow (Enable NetFlow).

For the further configuration of the Frame Relay follow the link :

http://www.cisco.com/en/US/docs/ios/12_0/wan/configuration/guide/wcfrelay.html#wp5157

New Member

Re: NetFlow on a Frame Relay - sub interface

Hi,

Thanks for your reply. Other frame relay interfaces which are not doing payload compression are available in the netflow cache entries. The only problematic interfaces are compression interfaces. Is it a limitation?

Blue

Re: NetFlow on a Frame Relay - sub interface

Yes, unfortunately NetFlow does not support compression at this point.

447
Views
0
Helpful
3
Replies
CreatePlease login to create content