Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Netflow on ATM Interfaces


I am having some issues getting netflow information to our server from our 800 series boxes.

I have enabled ip route-cache flow on the ATM0 interface but for some reason we only get data if we enable netflow on the dialer interface. I am wanting to know if this is an IOS issue or a problem with sending information when the dialer is bound? I have had some instances where I have needed to enable netflow on both interfaces and only get one way traffic from each.


Re: Netflow on ATM Interfaces

Having enabled NetFlow on both the ATM and Ethernet interfaces, a more complete picture of the traffic flows through this router was obtained. For example, in the route cache, an ICMP flow (ping echo request) arrived on interface ATM1/0.1 from IP address destined for IP address on interface Fa4/0. Because there was some visibility of flows on the Ethernet port, the ICMP echo reply, which arrived on interface Fa4/0 destined for interface AT1/0.1, could be seen.

With NetFlow enabled on all applicable interfaces, there was no need for the output of both routers (as in the Frame Relay example) to track the flow of IP packets.

For further information click this link.