Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Netflow on WS-C6506-E

Hi all,

 

I have configured netflow on a WS-C6506-E switch and having trouble exporting both inbound and outbound flows as on interface will only send outbound and another inbound.

 

My hardware type is -

Mod  Sub-Module                  Model              Serial       Hw     Status
---- --------------------------- ------------------ ----------- ------- -------
  4  Centralized Forwarding Card WS-F6700-CFC       SAL1525GTL8  4.1    Ok
  5  Policy Feature Card 3       WS-F6K-PFC3B       SAL1525GEL0  2.6    Ok
  5  MSFC3 Daughterboard         WS-SUP720          SAL1525GHHZ  5.1    Ok

and the IOS version is 122-33.SXJ

Netflow is configured as below

mls netflow interface
mls flow ip interface-full
ip flow-export source Loopback0
ip flow-export version 5
ip flow-export destination 161.163.96.206 9996

mls aging long 300
mls aging normal 60
mls netflow interface
mls flow ip interface-full
mls nde sender version 5

mls nde interface

 

The interface below only sends outbound flows

!
interface GigabitEthernet4/4
 description Uplink to UK-MINT-SW-03
 ip address 10.55.76.25 255.255.255.252
 ip flow ingress
 ip flow egress
 logging event link-status
 load-interval 30
 carrier-delay msec 0
 mls qos trust dscp
end

!

And only inbound flows here.

interface GigabitEthernet4/37
 description Uplink to R-AH-DIST-CR2
 ip address 10.55.63.249 255.255.255.252
 ip flow ingress
 ip flow egress
 udld port disable
end

any help would be greatly appreciated.

 

Jonathan

Everyone's tags (1)
124
Views
0
Helpful
0
Replies
CreatePlease to create content