Interface suppression, monitors packets passing from an interface to the switching bus and determines if the packet is unicast, multicast, or broadcast. The device counts the number of packets of a specified type received and sent within the one second time interval and compares the measurement with a pre-defined suppression-level threshold.
I didn't mean that. In a WAN accelerator , assume it has 2 interfaces A and B. A 50 MB traffic went in to the A interface comes out as 5 MB traffic. So I cannot use the ingress flow record that is exported by an interface A to put the outtraffic for interface B...How can I idetify the real out traffic using any analyzers?
Thanks for your input. But it seems you are talking about the suppression of interface information on a real data traffic. But my question was suppressing the output (destination interface) information on netflow record exported by a WAN accelerator.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.