I would like to run some NetFlow monitoring on a few sub interfaces on a router. This is a 7301, with an NPE-G1.
What I want to know is, does Cisco have a page anywhere (because I can't find one) that lists typical additional CPU and memory loads one can expect when enabling NetFlow on an (sub)-interface; perhaps for a given speed (Mbps) and/or number of flows?
I don't want to enable NetFlow and then bring the device to a grinding halt, how can I know what sort of overhead to expect?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...