Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NetFlow

Is it enought on Catalyst 4500 enable NetFlow Globally (of course IP routing is enabled from before) with command:

Switch# configure terminal

Switch(config)# ip route-cache flow

or

does it needs enable aggregation configuration

and

what is difference between:

. Autonomous System Configuration

*Destination Prefix Configuration

*Prefix Configuration

*Protocol Port Configuration

*Source Prefix Configuration

regards,

davor

1 REPLY
Silver

Re: NetFlow

To enable NetFlow (ingress) accounting for traffic arriving on an interface, use the

ip route-cache flow command in interface configuration mode.

129
Views
0
Helpful
1
Replies