In version 2.1 LMS had 2 ways of looking at the connectivity of switches on the network. One was the "Reachability dashboard" and the other I think was " 24 hr availability report". Is there anything similar in version 2.6 ? If I remember correctly each switch had a visual indication, Red down arrow if it wasn't reachable, and green up arrow if it was.
Availability and reachability were removed in LMS 2.5+. There is an add-on to LMS scheduled to ship this summer that will add MRTG-like capabilities to LMS 3.0. This will allow you to do some of the availability tasks that RME 3.x provided.
For now, DFM does provide fault information related to device reachability (though not in the same format that RME did in the past). You can use the Alerts and Activities Display under DFM to see if a device becomes unreachable.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...