Netshow jobs require telnet enable password?

[david.fernandes]

Do netshow jobs require the telnet enable password to run on switches (Cisco 6500 switches in particular)? I'm running a basic netshow job to do "sh ver" and it fails:

ERROR:RME_CDL1031:Transport session to device failed Couldnot enter ENABLE Mode from USER Mode on Device. Couldnot enter ENABLE Mode from USER Mode on Device.

[Joe Clarke]

Yes, Netshow must become enabled on the device before it will run commands.

[Howling76]

We use SSH to manage our network. Is there a way to have LMS (4.3.1)  use SSH to execute netshow jobs?

          thx, steve

[yjdabear]

Absolutely, just "promote" SSH above Telnet at " http://yourLMS:1741/rme/DcmaTransportSettings.do ", making sure Application Name is NetShow while making the change.