Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Netshow jobs require telnet enable password?

Do netshow jobs require the telnet enable password to run on switches (Cisco 6500 switches in particular)? I'm running a basic netshow job to do "sh ver" and it fails:

ERROR:RME_CDL1031:Transport session to device failed Couldnot enter ENABLE Mode from USER Mode on Device. Couldnot enter ENABLE Mode from USER Mode on Device.

3 REPLIES
Cisco Employee

Re: Netshow jobs require telnet enable password?

Yes, Netshow must become enabled on the device before it will run commands.

Community Member

Re: Netshow jobs require telnet enable password?

We use SSH to manage our network. Is there a way to have LMS (4.3.1)  use SSH to execute netshow jobs?

          thx, steve

Blue

Re: Netshow jobs require telnet enable password?

Absolutely, just "promote" SSH above Telnet at " http://yourLMS:1741/rme/DcmaTransportSettings.do ", making sure Application Name is NetShow while making the change.

484
Views
0
Helpful
3
Replies
CreatePlease to create content