Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Netshow output from the CLI?

I need a way to run a "show access-list" command on a PIX periodically so I can look at the number of hits.

I can run this command from the Ciscoworks CLI using:

./cwcli netshow createjob -u xxxx -p xxxx -device devicename -customcmd "show access-list"

This command successfully runs the job. Unfortunately, the output is not echoed, but is saved in report archive. I can have the job mail me when it is complete, but even that doesn't include the job output!

Is there a way with the "cwcli" commands to get this report, or have it echo the output, or write it to a file? Is there a better utility available to do this?

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Red

Re: Netshow output from the CLI?

Looks like bug id CSCsb26481: cmdoutput not shown in netshow cli

Looks like the fix will be in RME 4.0.3, available in November

1 REPLY
Red

Re: Netshow output from the CLI?

Looks like bug id CSCsb26481: cmdoutput not shown in netshow cli

Looks like the fix will be in RME 4.0.3, available in November

112
Views
0
Helpful
1
Replies