Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Network Assistans IOS Command Not Found

I have Cisco Network Assistant, I am attempting to connect to Cisco 4402 WLAN Controller. However, on descovery I get "IOS Command Not Found". Can anyone help me connect ? Many thanks.

3 REPLIES
Silver

Re: Network Assistans IOS Command Not Found

Network Assistant supports only autonomous access points. Access points that are managed by a wireless LAN controller are not supported.

If you run Cisco IOS 12.2(25)SEE or later, Cisco IOS 12.2(25)SEG or later, or Cisco IOS 12.1(22)EA7 or later, you must run Network Assistant 4.0 or later.

http://www.cisco.com/en/US/docs/net_mgmt/cisco_network_assistant/version5_0/release/notes/OL12210a.html#wp775718

Community Member

Re: Network Assistans IOS Command Not Found

Thanks for the answer -

It's not the Access Points I want to connect to, it's the WLAN controller.

Neil

Re: Network Assistans IOS Command Not Found

The WLAN controllers are not supported in CNA per the release notes. Keep in mind CNA was designed for switch management.

For WLC management, you can use other products such as WCS.

973
Views
0
Helpful
3
Replies
CreatePlease to create content