Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Network Assistant 5.0

I have three cisco access points on my network, all have the same SSID. Is there a way to get all three to show up in NA versus just the one? Right I see 1 AP with three connections.

2 REPLIES
Silver

Re: Network Assistant 5.0

I think Cisco Network Assistant supports only autonomous access points. Access points that are managed by a wireless LAN controller are not supported. Cisco Aironet 350, 1100, and 1200 series. Network Assistant supports them only if they run a Cisco IOS image. For more information please click following URL:

http://www.cisco.com/en/US/products/ps5931/prod_release_note09186a00807aea81.html#wp658039

Cisco Employee

Re: Network Assistant 5.0

Are the 3 access points added as members of a community and have separate IP addresses or are they neighbors of a member device ? Do you have other access points with separate SSIDs and they show up as separate entities ? if that is the case then your problem could be similar to another known issue where neighbors having same hostnames show up as single entity with multiple links from member device.

104
Views
0
Helpful
2
Replies