Has anyone had problems with ver 5.2 of Network Assistant with the CDP neighbors not showing up in the topology window? In version 5.1 it seems to work find but when I upgraded to ver 5.2 the cdp neighbors will not show up in the topology window.
I do have it turned on. We have some HP switches that have connections to the cisco switches. In ver 5.1 topology view I see the HP switches even though they say unsupported device, they show up in the view but in 5.2 they show up on the left pane under the neighbors but they do not show up on the right pane in the topolgy view. It is very strange that they don't show up
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...