I know that there are a lot of discussions about EoS/EoX not working on other software packages (LMS and/or RME) but I would like to add Network Compliance Manager to the list. We generate reports on the first of each month and it has been a couple months since we have gotten a successful report.
Are there any logs that I could include that would be of any help in identifying this issue?
I loaded the service pack for NCM (1.5.1) and EoS/EoX is
still failing! At least this time it is with a different error:
Exception in thread "main" java.lang.NullPointerException at com.cisco.nm.lib.eox.util.PopulateEoxDeviceInfoUsingAG.skip(PopulateEoxDeviceInfoUsingAG.java:105) at com.cisco.nm.lib.eox.util.PopulateEoxDeviceInfoUsingAG.createEoxModuleInfos(PopulateEoxDeviceInfoUsingAG.java:62) at com.cisco.nm.lib.eox.util.PopulateEoxDeviceInfoUsingAG.populateEoxDeviceInfo(PopulateEoxDeviceInfoUsingAG.java:45) at com.cisco.nm.cwncm.eox.EoxUtils.populateDevice(EoxUtils.java:138) at com.cisco.nm.cwncm.eox.EoxUtils.getEoxDeviceInfosEx(EoxUtils.java:84) at com.cisco.nm.cwncm.eox.EoxReportGenerator.main(EoxReportGenerator.java:333)
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...