Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Network Device Discovery.

Hi,

I have one Ciscoworks server with the following.

Common Services 3.1.0

Campus Manager 5.0.0

Cisco View 6.1.6

Default Device Manager 3.0.0

IPM 4.0.0

RME 4.1.0

I only installed this yesterday. I am having issue with Device Discovery where I put in the IP Address of our 6509 switch and put in the IP Address range (for example 10.2.0.0) for it to scan. However it is returning no results. I have added in the SNMP settings.

Is there anything I might be missing.

Thanks

Anthony.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Network Device Discovery.

Ugh, LMS 3.0.  You really should upgrade to LMS 3.0.1 which dramatically changes the way Discovery works.  You can download LMS 3.0.1 from http://www.cisco.com/cgi-bin/tablebuild.pl/lms301 .  Once done, apply the consolidated Discovery patch from CS 3.1.1 from http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-cd-one .  After that, configure Common Services Discovery under Common Services > Device and Credentials > Device Discovery as desired.  If you use CDP as the discovery method, make sure your seed device has CDP neighbors, and double-check the SNMP settings to make sure they match what is configured on the device.

1 REPLY
Cisco Employee

Re: Network Device Discovery.

Ugh, LMS 3.0.  You really should upgrade to LMS 3.0.1 which dramatically changes the way Discovery works.  You can download LMS 3.0.1 from http://www.cisco.com/cgi-bin/tablebuild.pl/lms301 .  Once done, apply the consolidated Discovery patch from CS 3.1.1 from http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-cd-one .  After that, configure Common Services Discovery under Common Services > Device and Credentials > Device Discovery as desired.  If you use CDP as the discovery method, make sure your seed device has CDP neighbors, and double-check the SNMP settings to make sure they match what is configured on the device.

177
Views
0
Helpful
1
Replies
CreatePlease login to create content