Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
jf
New Member

network registrar DHCP scope template question

How does one add more than one option to the Embedded Policy Option Expression in a DHCP Scope Template using Network Registrar 6.2.1?

When I use:

(create-option "routers" (create-ipaddr subnet 1))

(create-option "broadcast-address" bcast-addr)

and click modify, only the routers option shows up after I click modify.

When I use:

(

create-option

"routers" (create-ipaddr subnet 1)

"broadcast-address" bcast-addr

)

and click modify, it is accepted, but scopes using the template only end up with the router option anyway.

It doesn't accept commas between (), and I can find nothing in the manual about this.

Thanks for any insight you can provide.

1 REPLY
jf
New Member

Re: network registrar DHCP scope template question

for anyone wondering about this, here was the answer:

(list

(create-option "routers" (create-ipaddr subnet 1))

(create-option "broadcast-address" bcast-addr)

)

This came from TAC; I didn't find anything in the manuals.

106
Views
0
Helpful
1
Replies
CreatePlease to create content