I've figured out how to create and run Network Show batch reports that allow me to execute a command(s) on a group of devices like 'show port status'. By using the Batch jobs, I can run commands on more than 10 devices which is all that is allowed under Network Show Commands > Immediate Execution.
A Job # is created below:
in this case it assigned 1171. In that directory, there is a .log file. The first line in the .log file say this:
Remote console command is not enabled for the user cwsiver.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...