Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

New IOS>INSUFFICIENT MEMORY TO LOAD IMAGE!

Hello

I tried to put an other IOS on a 1721 but failed in doing this.

Flash was erased before putting the new IOS on it but I keep getting the message that there is insufficient memory.

In rommon I see:

rommon 1 > dir flash:

File size Checksum File name

8555996 bytes (0x828ddc) 0xd460 c1700-sy7-mz.123-13b.bin

With meminfo I see:

Main memory size: 32 MB.

Available main memory starts at 0x10000, size 32704KB

IO (packet) memory size: 25 percent of main memory.

NVRAM size: 32KB

So there is an IOS and there is sufficient space but what is going wrong?

Who can help me?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: New IOS>INSUFFICIENT MEMORY TO LOAD IMAGE!

Fred

I am not sure how you determined that there is sufficient space. When I look that release up in the software advisor I find that it requires 48MB DRAM which you do not have. Either you need to upgrade the memory on the router or you need to back down to a release that will fit into 32MB.

HTH

Rick

2 REPLIES
Hall of Fame Super Silver

Re: New IOS>INSUFFICIENT MEMORY TO LOAD IMAGE!

Fred

I am not sure how you determined that there is sufficient space. When I look that release up in the software advisor I find that it requires 48MB DRAM which you do not have. Either you need to upgrade the memory on the router or you need to back down to a release that will fit into 32MB.

HTH

Rick

New Member

Re: New IOS>INSUFFICIENT MEMORY TO LOAD IMAGE!

Hello Rick

I was convinced that the flash wasn't large enough but it is the ram.

Oops

Thank you for the quick response

YOur post was rated as helpful!

755
Views
0
Helpful
2
Replies
CreatePlease login to create content