Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

New switches not showing up in the DCR

I am running CWLMS 3.0.1

We recently added several switches to the network, yet they don't show up int the DCR. They are not excluded, and they are sending traps to the LMS. I am not over my license number (yet). What else could be stopping them from showing up in the DCR?

8 REPLIES
Cisco Employee

Re: New switches not showing up in the DCR

Is this LMS server integrated with ACS?

New Member

Re: New switches not showing up in the DCR

No, it is not. I have some 230 switches that are in there, but the last few have not been discovered.

Cisco Employee

Re: New switches not showing up in the DCR

Okay, so are you adding the switches to DCR manually, or are you expecting Discovery to pick them up automatically?

New Member

Re: New switches not showing up in the DCR

I am expecting them to be picked up automatically. Other switches that are connected to them were discovered. They are in the same IP address range, same IOS version as other switches, etc.

Cisco Employee

Re: New switches not showing up in the DCR

Please post the NMSROOT/conf/csdiscovery/CSDiscovery-config.xml as well as the output of show run for an affected device. If you cannot post this information, then please open a TAC service request.

New Member

Re: New switches not showing up in the DCR

Under Device Discovery I show that 461 Total devices discovered, 255 reachable devices (which are mostly the switches I want to manage), and 206 unreachable devices. I am only licensed for 300. Is this the problem? If so, how do I get rid of the unreachable devices. The RME collection shows only 247 devices in Inventory. And DCR shows 279 devices.

Cisco Employee

Re: New switches not showing up in the DCR

License has nothing to do with this. DCR is unlicensed, and can support up to 50,000 devices. If devices are showing as unreachable, they must not be SNMP reachable using the community strings configured in Discovery.

New Member

Re: New switches not showing up in the DCR

I will check my SNMP community string.

Thanks again for all your help.

292
Views
0
Helpful
8
Replies