Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No information In Device center

We have LMS3.2, CS3.3, RME4.3.1and  fully Integrated with ACS, Some devices are appared in device center without any information but they managed corrctly in RME.

Invetory poll job is succeed and  Sync Archive job is succeed   for those devices.

Please see attached files

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: No information In Device center

This means that there is some devices in the PIDM table which already are mapped to RME 4.3.1.  You need to get more tactical.  If you feel comfortable going through the table to change only the entries mapped to RME 4.3 which do not have a corresponding 4.3.1 entry, you can do that.  Else, talk to your TAC engineer again to get the SQL queries to do this.

4 REPLIES
Cisco Employee

Re: No information In Device center

It looks like you're seeing CSCtc21648.  There is a patch available from the TAC to correct this problem.

New Member

Re: No information In Device center

Thanks

New Member

Re: No information In Device center

I opened TAC and the problem is solved but now the problem back again for certain of devices as attached ... and when apply the SQL I get :

SQL Statement:

UPDATE PIDM_app_device_map SET app_version='4.3.1' WHERE app_name='RME' 

and app_hostname='sec5-12'




*** Error ***
Primary key for table 'PIDM_app_device_map' is not  unique (DBD: execute failed)

Cisco Employee

Re: No information In Device center

This means that there is some devices in the PIDM table which already are mapped to RME 4.3.1.  You need to get more tactical.  If you feel comfortable going through the table to change only the entries mapped to RME 4.3 which do not have a corresponding 4.3.1 entry, you can do that.  Else, talk to your TAC engineer again to get the SQL queries to do this.

458
Views
0
Helpful
4
Replies