Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No syslog message when 4507R SUP V-10GE is removed

I have a Cisco Catalyst 4507R with two Sup-Engine V-10GE.

When I remove from the chassis the active SUP-Engine, the switchover works fine, but there is no syslog message on the LMS syslog.

When I re-insert the module in the chassis, syslog messages appeared well on LMS syslog (module inserted).

The IOS is: 12.2(31)SGA1

the config is:

logging 172.30.7.240

!

snmp-server community fread RO

snmp-server community fwrite RW

snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart

snmp-server host 172.30.7.240 f1matread

1 REPLY
Cisco Employee

Re: No syslog message when 4507R SUP V-10GE is removed

What messages do you have in your logging buffer on the switch?

273
Views
0
Helpful
1
Replies
CreatePlease to create content