My LMS version is 3.0.1, running on windows system. I can see that my LMS receive syslog from NMSROOT/log/syslog.log, but in syslog alert there is no syslog records found.
In RME>Tools>Syslog>Syslog collector Status I try to unsubscribe then subscribe collector status. Failed on Subscribe collector status.
I go to Common Services > Server > Security > Multi-Server Management > Peer Server Certificate Setup, enter my IP address LMS server, after Importing Peer Certificate windows then Notification window appears (blank window). How to fix my syslog alert?
You do not need to accept your own server's certificate. If you cannot subscribe the Analyzer to the Collector, then one of the two may not be running. Please post the output of the pdshow command as well as the output of netstat -a -n -o -b.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...