Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Nothing other than seed device

As I execute Layer 2 View with in Campus Manager\Visualization\Topology Services..

All I see this the seed device and none of the other switches.

Dell Power Edge 2850

Intell Xeon 3.0 2.99, 2.00 GB Ram

MS Server 2003 W/sp 3

LMS 3.0.1:

CM 5.0

DFM 3.0

HUM 1.0

IPM 4.0

RME 4.1

Thanks for the help ahead of time.


Cisco Employee

Re: Nothing other than seed device

You may be running into a bug which was not fixed until CM 5.0.3 (meaning you will need to upgrade to LMS 3.0.1 then apply the 5.0.3 service pack). However, before that, make sure CDP is properly configured on your devices, and the show cdp neighbor command properly reflects the directly connected neighbors on the seed devices which are showing up on the map.

New Member

Re: Nothing other than seed device

Yes, CDP reflects the directly connected devices. I will up grade, and return with the results.