Choose Administration > System Settings. From the left sidebar menu, choose Notification Receivers. All currently configured servers appear on this page. From the Select a command drop-down list, choose Add Notification Receiver. Click Go. Enter the server IP address and name. Select either the North Bound or Guest Access radio button.
There is no specific MIB for wired devices,only available MIB for this is "CISCO-WIRELESS-NOTIFICATION-MIB".
we've tested the North Bound notifications for High Disk Utilization, and that works, a trap from the CISCO-WIRELESS-NOTIFICATION-MIB is sent.
so far in PI , most of the traps are for wireless devices .
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...