Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

objects show up even when nothing plugged into port - EEM Script

After a reboot my cisco shows the objects it tracks as up even when nothing is plugged into the interface used to track the objects. I have an EEM script that reboots the router 1 time when it finds that 4 dial numbers it round robins thru are unavialable and this works. The problem is after the reboot it see's the objects as available and re-inserts the reboot script and when they finally show down as they should be the reboot hapens over and over. Any Ideas on how to get the router to not show the tracked objects up after a reboot if the interface is down?

1 REPLY
Cisco Employee

Re: objects show up even when nothing plugged into port - EEM S

As I said in the other thread, I suspect the "delay down" is causing the behavior you are seeing.

202
Views
0
Helpful
1
Replies