Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

oid for both SUP??

Dear friends!

I am trying to plott mrtg for CPU and Memory Utilization of both (Active & Standby) SUP7203B on Cat 6513.

However while trying to retrieve OID through walk.. i am getting output for only Primary SUP.. Attached is the snap shot for it...

Can someone tell me how can i get OID for Standby sup?? Which MIB i should see it in??

1 REPLY
New Member

Re: oid for both SUP??

Attachment :)

92
Views
0
Helpful
1
Replies