Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Old CME Router Config

Hi,

I have the audacious task of replacing an old CME 3825 with newer 3925 to serve the same functions.

The 3825 has a service engine installed and configured along with 2 voice cards. The 3925 has 2 voice cards also installed.

I have done a lot of modifications on the config already but I have been stuck at one particular spot for a while. Below are the config lines where I am having this problem of configuring on the 3925:

!

!

interface GigabitEthernet0/1.10

encapsulation dot1Q 10

ip address 192.168.2.1 255.255.255.0

ip helper-address 192.168.0.10

ip nbar protocol-discovery

service-policy output OutboundPolicy

!

!

interface Service-Engine1/0

ip unnumbered GigabitEthernet0/1.10

service-module ip address 192.168.2.3 255.255.255.0

service-module ip default-gateway 192.168.2.1

!

ip route 192.168.2.3 255.255.255.255 Service-Engine1/0

!

!

dial-peer voice 29999 voip

destination-pattern 29999

session protocol sipv2

session target ipv4:192.168.2.3

dtmf-relay sip-notify

codec g711ulaw

no vad

!

dial-peer voice 21000 voip

destination-pattern 21000

session protocol sipv2

session target ipv4:192.168.2.3

dtmf-relay sip-notify

codec g711ulaw

no vad

!

I know the IP underlined above points to the service engine, but in the case where there is no service engine installed, how do I replace these config lines in the new router and still be able to retain the functions?

Regards,

Femi

215
Views
0
Helpful
0
Replies