I am trying to use the packet capture feature in LMS 3.0 Device Center, but it says I must have WinPcap installed before using it. I have installed WinPcap on my PC, but it still says that I need to install it. What else do I need to do to get this working?
The switches I want to do packet capture on range from: 2950, 3548, and 3560. I'm guessing that maybe I need to set something up on the actual switches??
Install, yes, but not to run. The way it works is that once it's loaded, it will run under any user. This is why we do not install WinPcap as part of LMS. We just include the installer, but leave it up to the admin to install.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.