Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Partially successful - Config archive

Hi,

We have LMS 2.6 with RME 4.0.5. For few devices we are getting partially successful in CONFIG ARCHIVE. In the log i found PRIMARY START-UP, RUNNING are failed but VLAN RUNNING was successful.

The error message is below,

1. 10.108.33.10 PRIMARY STARTUP Apr 24 2009 13:10:17 Failed to get the start tag-! in the configuration.Check if the startup-config file is present on the device. PRIMARY-STARTUP config Fetch Operation failed for TFTP. Failed to detect SSH version running on the device. Failed to fetch config using RCP.Connection refused: connect Verify RCP is enabled or not.

2. 10.108.33.10 PRIMARY RUNNING Apr 24 2009 13:10:35 Failed to get the start tag-! in the configuration.Check if the startup-config file is present on the device. PRIMARY-RUNNING config Fetch Operation failed for TFTP. Failed to detect SSH version running on the device. Failed to fetch config using RCP.Connection refused: connect Verify RCP is enabled or not.

3. 10.108.33.10 VLAN RUNNING Apr 24 2009 13:10:42 Successful

Pls help us to resolve this issue.

Thanks in advance.

Regards,

Pradeep

4 REPLIES
Cisco Employee

Re: Partially successful - Config archive

This is most likely caused by command authorization. Make sure the user configured in DCR has access to run "show running" and "show startup".

New Member

Re: Partially successful - Config archive

Hi Jclarke,

Thanks for your response. But the user i configured in DCR has the privilege for show running and show start. I manually logged in the switch with the same username and password and the show runn and start commands are working.

Cisco Employee

Re: Partially successful - Config archive

Then you should start a sniffer trace filtering on telnet traffic to this device. Perform a new Sync Archive to this device, then look at the sniffer trace when it fails. That should illustrate the problem.

New Member

Re: Partially successful - Config archive

I will do the sniffer trace and let you know.

245
Views
3
Helpful
4
Replies
CreatePlease login to create content