Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Partially successfull archives

I've been away for a few months and while on holiday it seems a number of my devices don't backup properly anymore. I'm getting lots of these messages:

Device: LN-BSQ-01-SERG-UAC-1 Status: Partially Successful

*** Device Details for LN-BSQ-01-SERG-UAC-1 ***

Protocol ==> Unknown / Not Applicable

CM0057 PRIMARY RUNNING Config fetch SUCCESS, archival failed for LN-BSQ-01-SERG-UAC-1 Cause: CM0002: Could not archive config Cause: Device may not be reachable, may be in suspended state or credentials may be incorrect. Action: Verify that device is managed, credentials are correct and file system has correct permissions. Increase timeout value, if required. Action: Verify that archive exists for device.CM0057 VLAN RUNNING Config fetch SUCCESS, archival failed for LN-BSQ-01-SERG-UAC-1 Cause: CM0012: Unable to create new version on archive $1 Action: Check if disk space is available and directory has required permissions Action: Verify that archive exists for device.

1. Credentials apear to be valid - I can ssh from the management server to the device using the same TACACS+ credentials

2. causer has permissions to the directory (Windows)

3. There is adequate free filesystem space (40Gb)

Am I missing something obvious?

Here is the credential verification report:

Device Name Read Community Read Write Community SNMPv3 Telnet Enable by Telnet SSH Enable by SSH Updated At

1. LN-BSQ-01-SERG-UAC-1 OK OK No Value To Test Protocol not configured. Did Not Try OK OK Jun 6 2007 17:10:49

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Partially successfull archives

The CM0012 error is most likely caused by CSCsh39475. A patch is available on Cisco.com at http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-rme .

If, after applying this patch, you are still seeing errors, you should enable ArchiveMgmt debugging under RME > Admin > System Preferences > Loglevel Settings, reproduce the problem, then look at the dcmaservice.log for errors.

2 REPLIES
Cisco Employee

Re: Partially successfull archives

The CM0012 error is most likely caused by CSCsh39475. A patch is available on Cisco.com at http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-rme .

If, after applying this patch, you are still seeing errors, you should enable ArchiveMgmt debugging under RME > Admin > System Preferences > Loglevel Settings, reproduce the problem, then look at the dcmaservice.log for errors.

New Member

Re: Partially successfull archives

You, Sir, are my new hero.

135
Views
0
Helpful
2
Replies
CreatePlease to create content