I've just upgraded the application software for this nam unit from 3.3 to 3.6 along with patches 1 and 2. After installing 3.6 I changed the login password from it's default. Now I'm unable to access the device from the application software login. I've tried the password recovery method of doing a harfware reset. I've also downgraded the application software version back to 3.3 and I was still unable to login. The documentation says that a harwdare reset should wipe the configuration but this doesn't seem to have happened.
Does anyone have any suggestions before I open a TAC case.
Thanks Davistan, Prior to making the changes I downloaded all the doco I could find and none of it had this information. But then none stated that .gz had to be added to the upgrade file when entering the FTP command without which the NAM unit will not recognise the file.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.