Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Path Analysis and interface Multilink

I tried to use Path Analysis for trace traffic from IP address of the end user PC (it is in UT database) and the Cisco router with IP address on the interface Multilink. The Cisco router is in the Campus database, but with management IP address. When I used Detailed device report - the IP address of interface multilink is seen. So Path Analysis has problem with this IP address. The trace is ended with message unknown IP address. What is the solution of this problem? Thank you.

1 REPLY
Silver

Re: Path Analysis and interface Multilink

try the following :

1. Go to the server and do a trace route to check that all devices are reachable and also be sure that all devices in the path are reachable.

2. Check the VTP configuration on the devices.

check out the following troubleshooting link for more information :

http://www.cisco.com/en/US/products/sw/cscowork/ps563/products_user_guide_chapter09186a00805af624.html#wp1184090

105
Views
0
Helpful
1
Replies
CreatePlease login to create content