Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

PI 2.1 Image Distribution across NAT boundary fails

I cannot distribution images to network devices across a NAT boundary. I believe PI is using it's private IP address for the copy commands. Is there any way to change that to it's NAT address?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi Seth,AFAIK, NAT is still

Hi Seth,

AFAIK, NAT is still not supported in PI ,however this is in the raod map.

 

Thanks-

Afroz

***Ratings Encourages Contributors ***
 

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
2 REPLIES
Cisco Employee

Hi Seth,AFAIK, NAT is still

Hi Seth,

AFAIK, NAT is still not supported in PI ,however this is in the raod map.

 

Thanks-

Afroz

***Ratings Encourages Contributors ***
 

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Bummer, ok. Is there any way

Bummer, ok. Is there any way I could get a look at the roadmap?

30
Views
0
Helpful
2
Replies
CreatePlease to create content