Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Ping Sweep on specific IP range

Hello!

I have a question concerning Ping Sweep On IP Range function in LMS 3.2.

The costumer have MPLS cloud so CDP discovery is not functional.

There are more then 400 branches.

I would like to set the specific ip Range like following because the B class mask is to large for discovery process ( ~7,5 day )

10.31.1-50.0 / 255.255.255.0

10.32.1-50.0 / 255.255.255.0

10.33.1-50.0 / 255.255.255.0

10.34.1-50.0 / 255.255.255.0

10.35.1-50.0 / 255.255.255.0

10.36.1-50.0 / 255.255.255.0

10.37.1-50.0 / 255.255.255.0

10.38.1-50.0 / 255.255.255.0

10.39.1-50.0 / 255.255.255.0

What is the right syntax in this case ?

Regards,

1 REPLY
New Member

Re: Ping Sweep on specific IP range

Hi,

i tried the following syntax in ping sweep seed devices.

.

.

.

10.39.[1-50].240      255.255.255.240

.

.

The log shows the following

[Feb 26  12:29:02] FATAL  [PingSweepDiscoveryModule : main initialize]  : getting seed device ipaddress failed10.31.[1-200].240: 10.31.[1-200].240
[Feb 26  12:29:02] FATAL  [PingSweepDiscoveryModule : main initialize]  : getting seed device ipaddress failed10.32.[1-50].240: 10.32.[1-50].240
[Feb 26  12:29:02] FATAL  [PingSweepDiscoveryModule : main initialize]  : getting seed device ipaddress failed10.33.[1-50].240: 10.33.[1-50].240
[Feb 26  12:29:02] FATAL  [PingSweepDiscoveryModule : main initialize]  : getting seed device ipaddress failed10.34.[1-50].240: 10.34.[1-50].240
[Feb 26  12:29:02] FATAL  [PingSweepDiscoveryModule : main initialize]  : getting seed device ipaddress failed10.35.[1-50].240: 10.35.[1-50].240
[Feb 26  12:29:02] FATAL  [PingSweepDiscoveryModule : main initialize]  : getting seed device ipaddress failed10.36.[1-50].240: 10.36.[1-50].240
[Feb 26  12:29:02] FATAL  [PingSweepDiscoveryModule : main initialize]  : getting seed device ipaddress failed10.37.[1-50].240: 10.37.[1-50].240
[Feb 26  12:29:02] FATAL  [PingSweepDiscoveryModule : main initialize]  : getting seed device ipaddress failed10.38.[1-50].240: 10.38.[1-50].240
[Feb 26  12:29:02] FATAL  [PingSweepDiscoveryModule : main initialize]  : getting seed device ipaddress failed10.39.[1-50].240: 10.39.[1-50].240

How can i strict the ping range for the discovery process???

Thanks in advance!

839
Views
0
Helpful
1
Replies
CreatePlease to create content