Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 501

hello,

i have some problem to configure my PIX 501 (firewall & VPN).

my problem is on the outside interface. the link is down and the interface is shutdown.

i think that this both thing are link but i don't fine a way to put at up the link.

more over there is no help on the web and on the cisco's help...

2 REPLIES
Silver

Re: PIX 501

You can try configuring "interface hardware_id hardware_speed". The interface command identifies the interface hardware card, sets the speed of the interface, and enables the interface all in one command. All interfaces on a Cisco PIX Firewall are shut down by default and are explicitly enabled by the interface command.

New Member

Re: PIX 501

after writing that " interface ethernet0 100full" on a telnet session and after a "reboot" there is no change on my PIX!!!

i show with the PDM that my outside interface is always down, the line protocol for ethernet0 (outside interface) is down too. More over there is a red cross on the interface...

i dont know what i have to do for this device

On the PDM/Configuration/System Properties/Interface

when i edit the outside interface properties i saw that everything is enable (the interface and the properties of hardware port).

115
Views
0
Helpful
2
Replies
CreatePlease login to create content