Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX Dynamic NAT logging into syslog

Can any body assist me in how to log the dynamic translations happening in the PIX 510 to a syslog server.We have done the configuration of Dynamic NAT translation logging to a syslog server in a 7206 router.The command line says ip nat log translation syslog.Can someone help me whether there is any similat commandline in pix.

2 REPLIES
Anonymous
N/A

Re: PIX Dynamic NAT logging into syslog

here are steps to set up syslog on pix :

1. Logging on pix buffer:

pix(config)#logging on

pix(config)#logging buffered debugging

To view logs :

pix(config)#show log

NOTE: This will display all messages on pix and could cause problems on the pix, so the

suggested thing is to use a syslog server on the inside interface of the pix.

2. Logging into a server

a) Set up a PC that is going to work as a syslog server

b) Configure pix:

pix(config)#logging on

pix(config)#logging trap debugging

pix(config)#logging host inside x.x.x.x

where x.x.x.x is the ip address of the PC that is going to work as syslog server

This will send all messages to server

New Member

Re: PIX Dynamic NAT logging into syslog

Hi, I was wondering if you would mind sharing the config for the 7206 router. I am trying to get this to work for a 870 router. It logs to the router but not the syslog server. I have applied the command:

ip nat log translations syslog

My syslog is receiving other messages okay. I am running c870-advsecurityk9-mz.124-4.T1.bin.

Many thanks in advance for your help.

Tracey

225
Views
0
Helpful
2
Replies
CreatePlease login to create content