Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

pix limited bandwith

I hope this is the right place where I can post my problem: I just want to limit traffic on my pix's ethernet interface.. is it possible?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: pix limited bandwith

Hello,

in the same document you find a section entitled "Activating the Service Policy", where you find the command:

hostname(config)# service-policy qos interface outside

One service policy can be applied per interface.

A sample configuration to limit all traffic across an interface, which should be close to what you need:

hostname(config)# policy-map Limit1MB

hostname(config-pmap-c)# class class-default

hostname(config-pmap-c)# police output 1000000 37500

hostname(config)# service-policy Limit1MB interface outside

You can also use other interfaces and apply the service-policy.

Hope this helps! Please rate all posts.

Regards, Martin

4 REPLIES

Re: pix limited bandwith

Hello,

with version 7.0 QoS is part of the PIX features. This includes rat limiting. For a detailed explanation of possibilities and limitations please read in the "Cisco Security Appliance Command Line Configuration Guide, Version 7.0" the section on rate limiting: "Applying Rate Limiting"

http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a0080450b9a.html#wp1045477

Hope this helps! Please rate all posts.

Regards, Martin

New Member

Re: pix limited bandwith

thank you! that seems to be really helpfull.. however I could not find a way to apply qos to an ethernet interface. T-T

Re: pix limited bandwith

Hello,

in the same document you find a section entitled "Activating the Service Policy", where you find the command:

hostname(config)# service-policy qos interface outside

One service policy can be applied per interface.

A sample configuration to limit all traffic across an interface, which should be close to what you need:

hostname(config)# policy-map Limit1MB

hostname(config-pmap-c)# class class-default

hostname(config-pmap-c)# police output 1000000 37500

hostname(config)# service-policy Limit1MB interface outside

You can also use other interfaces and apply the service-policy.

Hope this helps! Please rate all posts.

Regards, Martin

New Member

Re: pix limited bandwith

thank you.. it has been really helpful!

117
Views
0
Helpful
4
Replies