10-07-2005 01:37 PM
I am trying to access my PIX 525 via telnet through Ciscoworks. I have enabled telnet per the instructions but it fails everytime. I assume there is an access-list that I need to create but I'm unsure as to what address to use. I tried the address that snmp is able to connect with but that fails.
10-07-2005 08:41 PM
Hi
There was a good post out there in security where opening the port for telnet access both from out and in .
its not possible to open telnet or do telnet on outside interface only SSH is permitted and from inside do find the link which will help u out..
regds
10-10-2005 09:05 PM
More simple you need to add 'telnet AAA.BBB.CCC.DDD 255.255.255.255 inside' to your global config. The AAA.BBB.CCC.DDD being the IP address of the host in where you want to telnet from. You could specify a whole subnet there by using a /24 or other netmask, but that's not very secure is it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide