Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

polling OID on 3750 in order to retrieve power details (main or redundant)

Hi,

We have catalyst 3750 switches with redundant power supply (RPS) 675.

We intend to monitor when the power switches from the main power to the RPS 675. The aim is to know if the 3750 is runing under "built-in POWER" or under "redundant POWER".

According to the release notes, the RPS doesn't send trap or any other kind of messages.

It seems the only way is from the 3750 to send SNMP trap or to request by SNMP an OID that would give the state of the power and wether the RPS to be activ or not.

Do you confirm ?

Do you know the MIB to be used and the OID to target ?

I've downloaded on cisco FTP site the mib "CISCO-ENVMON-MIB-V1SMI.my". I guess it should be the right.

The 3750 are in version 12.2(25)SEE2.

Thanks in advance for your attention.

Best Regards,

Arnaud

  • Network Management
1 REPLY
Cisco Employee

Re: polling OID on 3750 in order to retrieve power details (main

You can poll the ciscoEnvMonSupplyStatusTable from the CISCO-ENVMON-MIB (1.3.6.1.4.1.9.9.13.1.5) to see all your PS statuses.

410
Views
5
Helpful
1
Replies
This widget could not be displayed.