Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Populating Devices in Topology Groups in Campus Manager/Topology Services

Hello All:

For some reason, when I go into Topology Services in Campus Manager, the default network views are populated with discovered devices, but when I go into topology groups, all the default groups (i.e. CS, RMS, Campus) show zero devices. There are devices setup in the DCR, so my assumption is those corresponding devices should show up here, too.

Is there something I am missing here? Is there some way I should be manually populating these groups?

I'm running Campus Manager 4.0.4 on LMS 2.5

Thanks.

2 REPLIES
Silver

Re: Populating Devices in Topology Groups in Campus Manager/Topo

You may need to drill down into these groups before you will see any devices

Cheers,

Michel

New Member

Re: Populating Devices in Topology Groups in Campus Manager/Topo

When I drill down I still don't see any devices.

121
Views
0
Helpful
2
Replies
CreatePlease to create content