Today i was trying to configure port forwarding in one of my client's office. They wanted me to forward ports like 5000 and 6000. I was given the GUI access of the cisco router 2900 series. I could not see any options for NAT or ACL there. I doubt we can't forward ports from that particular router. Help me if there is any way we can do that via CLI.
My private ip is 172.16.32.250 and my private is 188.8.131.52. When someone does 184.108.40.206:5000 from their browser outside the office, i want them to have the interface of my biometric devices. I want TCP 5000 to be opened/forwarded.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...