Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port Monitor 3745

I have a 3745 with a 36 port switch module. I want interface F4/0 to monitor F4/11. Under the interface commands I do not see the port monitor command.

Not sure if this is possible or not.

1 REPLY
Silver

Re: Port Monitor 3745

The command monitor session session_number source interface interface-id [, | -] [both | rx | tx] will work. Try applying the following configuration

monitor session 1 source interface aaaaa

monitor session 1 destination interface bbbbb

For more information please click following URL:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3550/software/release/12.1_11_ea1/configuration/guide/swspan.html#wp1036829

203
Views
0
Helpful
1
Replies