Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port Monitor on 6513

I am troubleshooting a vlan spanning issue on a 6513 switch and am looking for any suggestions. Here are the particulers:

Version 12.2(18)SXD3

monitor session 1 source vlan 69

monitor session 1 destination int g6/35

Show monitor returns:

Type Local Session

Source VLANS

Both 69

Destin Ports Gi6/35

The traffic happens to be routed between vlan 60 and vlan 69, both on the switch. When I capture the traffic, it looks as though I am only receiving half of the conversation(from vlan 69-->vlan60). I don't see the other half of the conversation.

The strange part is, I have a half dozen ports on a connected 3750 switch in vlan 69 that I see all of their traffic. So I am looking to the 6513 for issues/problems.

Anybody have some suggestions?

Thanks

1 REPLY
Cisco Employee

Re: Port Monitor on 6513

Hmm...its been a while since I worked on this, but are there ports where you are seeing half of the traffic set to half-duplex vs full-duplex for the ones showing all traffic?

166
Views
0
Helpful
1
Replies