I need to setup some parameters related to port security features on my SG, SF series switches via SNMP. I've found that it is possible with port security MIB (220.127.116.11.18.104.22.168.315). I found out my devices has support of this MIB downloading archive with MIBs from cisco site. But when I try to read some parameters from this MIB via SNMP, for example "cps if port security status" (22.214.171.124.126.96.36.199.3188.8.131.52.1.2) device answers with: "No Such Object available on this agent at this OID". But it is possible to do with web-interface in Security->Port Security section
How is it possible to read/write such type of parameters ?
I'm writing a PHP web-shell to centralize network management via SNMP. The purpose I'd like to achieve is the posibility to set up MAC static list with secure option enabled and I can do that via SNMP. But before I can set up secure option for the MAC I need to switch interface status to "Locked" and THIS is the problem I'd like to find the solution for.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...