Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Port Utilization reports on LMS3.1

I am looking for a way to pull a report that will give me the port utilization % for each device. I have scrubed this application and to no avail. I am running LMS 3.1 on Windows. I have RME, DFM, IPM, Campus Manager all installed.

Can someone point me in the right direction?

Thank you

3 REPLIES
Cisco Employee

Re: Port Utilization reports on LMS3.1

You will need to install the Health and Utilization Monitor add-on. By default, you will get a 90-day of HUM. You can then configure an Interface Utilization poller for your devices which will provide you what you want.

Community Member

Re: Port Utilization reports on LMS3.1

Thank you jclark

I have Unified Operations Manager as well. I found a report that says VG utilization. But when I run the report, it only tells me the status of the VG's, not the utilization. Is there a way to get report port utilization from the OM on the Voice Gateways?

Cisco Employee

Re: Port Utilization reports on LMS3.1

You should start a new thread for the OM question. I know OM tracks utilization, but it will not maintain a history as HUM will do.

320
Views
0
Helpful
3
Replies
CreatePlease to create content