Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ports/protocols used between LMS 3.2 and devices

What ports need to be opened on firewall to allow the CiscoWorks LMS 3.2 to discover and manage devices outside the firewall?  The device needs to be managed by RME CM DFM

1 REPLY
Blue

Re: ports/protocols used between LMS 3.2 and devices

It rather depends on what protocols you want LMS to use to "manage" devices, configured at such places as RME -> Admin -> Config Mgmt -> Transport Settings:

Here's a comprehensive list, with most for internal communications on the LMS host:

https://supportforums.cisco.com/docs/DOC-4677

One doesn't need to open "514/tcp (RCP port)" if RME isn't configured to use it, for example.

In reality you probably can get away with only opening a subset of the ports in this post below, plus UDP port 162 (SNMP traps) for DFM:

https://supportforums.cisco.com/message/1329162#1329162

599
Views
0
Helpful
1
Replies
CreatePlease to create content