I am wondering what I need to do to get the location of my wired clients to show in the correct locations. As you can see in the attached image they are not showing in any of the charts. They do however show in the graphs and in the "operate - clients and users" lists, but the location information is blank. I have all of the switches in a location group and everything appears to be working without error.
I also noticed that in the details of the client it knows which switch it is on, which port it is on and other usefull details. So why is it that prime cannot distinguish that if it is on switch A port 22 which is part of Group Y that it is in location Y?
Is there something else I have to do in order for the wired clients to show a location?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...