cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2109
Views
0
Helpful
3
Replies

Prime 2.0 with SW 3850 : Collection error:Wireless Controller inventory collection failed

mmisonne
Level 2
Level 2

Hello

I have lots of SW 3850 which failed on inventory collection with an error:

" Collection Status

Collection Other error: Wireless Controller inventory collection failed.
Status :  Failure to collect feature DCAConfig"

Half of the devices (50 upon 100)  have this error.

Allthoug  Prime can archive  the configuration of all switches..

When I tried to Re-sync the faulty  devices , a few  goes OK:  ( i.e. inventory completed)

I tried to increase the timer ( snmp from 6 sec to 18 sec,   and SSH from 60 to 180 sec) without success.

All the SW 3850 have the same snmp  and tacacs config..

They are not configured as wireless controller.

Could someone help me ?

Michel Misonne

3 Replies 3

Rob Johnson
Cisco Employee
Cisco Employee

half are working and half are not huh?

Something must be different between them?

Are the ones that are working perhaps configured as wireless controllers?

Thanks for your answer.

Finally, all my 3850 are now in state "inventory completed"

It takes 1 day more to achieve this.

And I changed nothing in the configuration !

So I do not know why it takes so long ?

Perhaps , if the collection use SSH credential, it goes to timeout  because the tacas-server was responding slowly.

Or perhaps, because the 3850 are stacked ( 4 or more switch in a stack) , this could explian why it takes so long..

Regards

Michel

Saurav Lodh
Level 7
Level 7

Please refer to this discussion

https://supportforums.cisco.com/docs/DOC-33662

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco