Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Prime Infrastructure 1.3 can auto build network diagram?

hi,

I am new to Prime Infrastructure, just want to confirm that Prime Infra v1.3 can auto build network diagram for switch and router (NOT AP). Just like Cisco work campus manager before?

Thanks...KEN

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Prime Infrastructure 1.3 can auto build network diagram?

Hi Ken,

Topology service is not supported in  PI 1.x  and PI 2.0 yet , however it is in the road map. May be we will have this feature supported in PI 2.1

for the feature support and comparison , you can check the below link:

http://www.cisco.com/en/US/prod/collateral/netmgtsw/ps6504/ps6528/ps12239/guide_c07-729089.html

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
3 REPLIES
Cisco Employee

Re: Prime Infrastructure 1.3 can auto build network diagram?

Hi Ken,

Topology service is not supported in  PI 1.x  and PI 2.0 yet , however it is in the road map. May be we will have this feature supported in PI 2.1

for the feature support and comparison , you can check the below link:

http://www.cisco.com/en/US/prod/collateral/netmgtsw/ps6504/ps6528/ps12239/guide_c07-729089.html

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Re: Prime Infrastructure 1.3 can auto build network diagram?

hi Afroz,

Thanks.

Thanks...KEN

Cisco Employee

Re: Prime Infrastructure 1.3 can auto build network diagram?

Hi Ken,

Kindly resolve the thread..

Thanks-

Afroz

[Do rate the post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
419
Views
0
Helpful
3
Replies
CreatePlease to create content