We configured one PI2 pair as described in the config guide (Automatic Mode) in same subnet and verified in the GUI, that the Failover-Pair is accepted as configured. Than we testet via driving down the Primary and nothing happened even after 1 hour:
No Login at Primary-IP ( in case of a redirect or SW-loadbalancing - documentation says nothing about how the Frontend should work in event of a Failover) nor at Secondary IP possible.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.